A valid cargo run stages the correct crate, moves it to a site that accepts it and sets it down at that site's delivery point.

Open the radio menu with # on the ground or Alt+# in the air, then press F10 to select Other. The paths below start inside the Other menu.

For internal transport, use only the Cargo entry to load and unload Torque Tycoon crates. DCS's built-in rearm/reload and cargo-loading menus do not work with these crates.

1. At the Source or Factory, open Tycoon > My Location > Storage.
2. Select the required cargo and choose a number of crates, Spawn max free slots or Spawn max payload.
3. Position the aircraft close enough to the crates, then use Cargo > Load nearby to load them.
4. Open Tycoon > Navigation > Cargo Sites and use Refresh nearest sites if the cargo was just loaded.
5. Select the destination and use Deploy smoke when a visual marker is useful.
6. Approach the destination's delivery point (see the table below).
7. Settle low and almost stationary, then unload with Cargo > Drop loaded.

Success. The matching crate is consumed by the destination and its stock, Reserve or operating state changes. Crates at helipads are placed in free positions around the pad so that they do not stack or block the landing spot. At an airfield, they are set down behind your aircraft, so any parking position near the Tycoon tent will do.

If the delivery does not count. Read the radio-menu result and check that the aircraft was settled at the correct delivery point and that the site accepts the cargo. When the aircraft stands at a site that does not take the cargo, the message names that site and the refused cargo.

• Settlement Food store FULL: it takes no more Food. Fly the crate to a Settlement that still has room before the second restart.
• Airfield storage full: the message shows the storage as x/y. The crate stays on the ground. Load it again and unload it once there is room, or fly it elsewhere before the second restart.
• Cargo Sites empty: it stays empty until internal cargo is aboard.
• Source looks blocked: inspect its stored and staged crates before assuming that production has failed.

The C-130J-30 cannot land on a helipad. It collects near a pad and delivers to an airfield, where helicopters take the cargo on.

1. Land and stop within 100 m of the Source's or Factory's pad.
2. Open Tycoon > My Location > Storage and take the crates out. They appear behind the aircraft.
3. Load them with Cargo > Load nearby.
4. Fly to an airfield, park within 500 m of the Tycoon tent and unload with Cargo > Drop loaded. The crates go into the airfield's storage.
5. For the last leg, a helicopter takes them out of the airfield's Storage and delivers them to a pad.

A Hub, City or Factory accepts a delivery only with the aircraft on its pad, so an airplane cannot deliver there directly. See Airfields.

1. Choose the destination from the Live Map or the nearby-site navigation before lifting the crate.
2. Attach the Tycoon crate with the helicopter's normal cargo-hook controls.
3. Fly it to the appropriate helipad, marked construction point or airfield and set it down there.
4. Tycoon detects the sling pickup and set-down automatically. No additional internal load-and-drop cycle is required.

Cargo Sites is based on internally loaded cargo and may therefore remain empty while a crate is on the hook.

• Cargo
• Aircraft
• Airfields
• Sources
• Factories
• Radio Menu
• Live Map

• Complete Your First Flight
• Choose a Useful Task
• Commission a Site
• Build a Project